How To Disassemble An Xbox One Controller

Introduction

This guide will teach y'all how to remove the buttons.

• Remove the battery pack cover.

• Remove batteries.







• We recommend using a nylon spudger for this step. A metal spudger is shown.

• Grip the controller firmly to remove the side handles, wedging a spudger into the seam betwixt the front and handle plates.

• Pry the side plate away from the front plate past moving the spudger back and along. You will need to do this all the way effectually the side plate'southward seam.

• There is a hidden screw located in the center of the controller behind the label.

• Use a screwdriver and punch a pigsty directly in the heart of the label.

• You may also lift the label if you lot do not desire to puncture information technology.

• Remove the five 10mm screws located on the back of the controller using the T8 Security Torx Screwdriver.

• Remove the backplate.

• Remove the faceplate.

• Y'all may let the rumble motors hang freely out of their sockets.

• De-solder the soldered joints while holding the ruby-red and black wires downwardly on the top motherboard.

• De-solder the black and greyness wires that are attached to the top motherboard.

• Remove the rumble motors and ready them aside.

• Be careful while using the soldering iron not to damage other components or hurt yourself.

• For data on how to solder, click here.

• Unscrew the two 7mm T6 screws located about the rumble motor sockets.

• Firmly grip sides of motherboard near the centre.

• Lift upwards while slightly wiggling the motherboard forwards and backward.

• Lifting the motherboard will require some forcefulness.

• Remove the 6 T6 Torx screws located on the bottom motherboard.

• Remove the bumpers by prying them off of the pegs that secure them, using a spudger. They are located on the front end and back of the controller.

• A standard nylon spudger is recommended for this step. Using a metal spudger nigh the motherboard every bit shown risks damaging your device.

• Lift the piece surrounding the Habitation button off of its pegs.

• Pry it off of the other side, using a spudger on the pins.

• A standard nylon spudger is recommended for this step. Using a metal spudger almost the motherboard as shown risks damaging your device.

• Removing this piece may require a lot of force.

• Remove the bottom motherboard.

• Remove the safe backing to the buttons.

• With the buttons facing downward, push them upwards out of their housings, and remove.

Conclusion

To reassemble your device, follow these instructions in reverse society.

Team

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview

How To Disassemble An Xbox One Controller,

Source: https://www.ifixit.com/Guide/Xbox+One+Wireless+Controller+Buttons+Replacement/36845

Posted by: powellgoiderearsur.blogspot.com

Share this post